Ball Stretching

Some heavier weights

Facebooktwittergoogle_plusredditpinterestlinkedinmailFacebooktwittergoogle_plusredditpinterestlinkedinmail

11 Comments

  • easyone73070
    easyone73070
    July 5, 2017 - 12:17 pm | Permalink

    Beautiful pictures, great stretching. Keep the pictures coming as you increase the weights.

    • Peter
      July 24, 2017 - 5:48 pm | Permalink

      Hey bud. Just wanted to ask you a question. I bought a 30mm inner diameter but my balls slip thru it. I’m a average size build not really huge balls. I want to keep it and stack it later. Do you suggest I go for a 28mm or 26mm inner diameter

  • ssttpp8
    July 6, 2017 - 11:30 am | Permalink

    Thanks. Good luck with your pumping.

  • Juan martin
    July 7, 2017 - 4:22 am | Permalink

    Great products , love them

  • bigben5701
    July 18, 2017 - 1:41 am | Permalink

    Great pictures. Love your stretch. How long is your stretch without the weights?

  • ssttpp8
    July 18, 2017 - 3:36 am | Permalink

    Hi Ben..thanks…depends on the temperature. (hotter = bigger relaxed hang). Probably 4-5 inches. Definitely more length than before I started stretching. I wear a couple of pounds daily…on a fairly regular basis.

  • ssttpp8
    July 18, 2017 - 3:45 am | Permalink

    Hi Ben…thanks. Depends on the temperature. (hotter temps = bigger hang) Probably around 4-5 inches. Definitely a bigger hang than before I started stretching. I usually wear 1-2 lbs daily for 12+ hours (60-70 cm width)

  • Peter
    July 24, 2017 - 6:21 pm | Permalink

    Any guys have a suggestion.
    I bought a 30mm inner diameter but my balls slip thru it. I WANTED to keep it so I can stack it later down the road. What should I go for 28mm or 26mm inner diameter. My balls are not that huge.

  • ssttpp8
    July 26, 2017 - 2:43 am | Permalink

    Hard to say…I’d probably try the 28mm…and return them for the 26mm if you slip thru.

  • ssttpp8
    July 26, 2017 - 11:37 am | Permalink

    Peter, depending on how easily they “slipped thru” I’d be tempted to go with the 28mm…as too small a diameter won’t work and comfort is important. You may have to return for a smaller size if the 28mm is still too big.

  • Henry
    August 5, 2017 - 11:02 am | Permalink

    try using a rubber o ring . Had the same problem and went to ace hardware and got a thick o ring. Put weights on than a o ring to stop your nut from slipping through.

  • Leave a Comment

    Your email address will not be published. Required fields are marked *

    *

    Protected by WP Anti Spam
    Powered by: Wordpress